ENGINEERING DRAWING ASSIGNMENT : (CSE – B & C, MECH, ECE – B)
22/12/2015
- Submit the Assignment in Drawing Book before entering in to the Drawing Hall at the time of Exam & Submit all the Drawing Sheets also.
ENGINEERING DRAWING
II MID EXAM:
I CSE
C: 20/01/2016 AN
I CSE B:
21/01/2016 FN
I MECH:
21/01/2016 AN
I ECE B:
22/01/2016 AN
1. Draw the projections of the
following points on the same ground line, keeping the projectors 20mm apart.
(a) Point A in the VP and 40mm above
HP.
(b) Point B 25mm below the HP and 25mm
behind the VP.
(c) Point C 15mm above the HP and 50mm
behind the VP.
(d) Point D 40mm below the HP and 25mm
infront of the VP.
2.
A line AB of 100 mm length is inclined 300 to HP and 450
to VP. The point A is 15mm above HP and
20mm infront of VP. Draw the projections of the line.
3. A room measures 8m long, 5m
wide and 4m high. An electric bulb hangs
in the center of the ceiling and 1m below it. A thin straight wire connects the
bulb to switch kept in one of a corner of the room and 1.25m above the floor.
Draw the projections of the wire, also determine its true length and slope with
the floor.
4. a). A 90 mm long line is
parallel to and 25 mm in front of the V.P. It’s one end is in the H.P. while
the other is 50 mm above the H.P. Draw it’s projections and find it’s
inclination with the H.P.
b). The top view of a 75 mm long
line measures 55 mm. The line is in the V.P. It’s one end being 25 mm above the
H.P. Draw it’s projections.
5). A semi circular
plate of 80mm diameter has its straight edge in the V.P. and inclined at 600
to the H.P, the surface of the plate makes an angle of 300 with the
V.P. Draw its projections.
6). A regular pentagon of 30mm side, has one of its corners on V.P. and its
surface is inclined at 600 to the V.P. the edge, opposite to the
corner on V.P. makes an angle of 450 with H.P. Draw the projections
of the plane.
7). A regular hexagon of 40mm has a corner in the H.P. Its surface is inclined at
450 to the H.P. and the top view of the diagonal through the corner
which is in the H.P. makes an angle of 600 in the V.P. Draw its
projections.
8). A pentagonal
pyramid base 25mm side and axis 75mm long
has one of its triangular faces in the VP and the edge of the base
contained by that face makes an angle of 300 with the HP Draw its projections.
9). Draw the projections of a hexagonal prism of base 25mm and axis 60mm long, when it is resting
on one of its corners of the base on H.P. The axis of the solid is inclined at
450 to the H.P.
10). A cone of base diameter 50mm and axis 70mm long rests with one of the
points on the circumference of its base on H P. Its axis is inclined at 350
to HP and 450 to VP. Draw its projections